Combine back/horizontal instructions

 

Machining centre transfer parameter to combine back and horizontal instructions for nested part MPR(X) files

 

When transferring a nested run to a machining centre, if this option is checked then horizontal and back instructions are put into an MPR(X) without an NCSTOP for turning the part over. This is for machines that can do both types without turning the part.

 

This parameter applies to the MPR(X) parts created for nested patterns (e.g. the nested patterns files have front instructions and the part files have back/horizontal instructions).It requires the NE module for the parameter to be available.

 

If this parameter is not checked then the part MPR(X) will have the horizontal instructions first and then an NCSTOP (so the part can be turned over) and finally the back instructions.

 

Notes

 

- If either of the separate files(s) parameter is checked (for back or horizontal), then the parameter will have no effect.