Saw parameters to define whether manual processing is allowed and the positioning of manually pro-cessed patterns in the run
These parameters are only available for saw model 26 HOMAG flexTec CADmatic 5 and appear on the Cutting 3 tab.
Some HPS flexTec configurations allow a manual production mode as well as an automated robotic mode. When this is the case the "Allow manual processing" option should be set.
When manual processing is allowed, optimisations will still favour patterns that can be processed automatically but will also allow the production of parts and use of boards that can only be handled manually.
Users can also configure the order of patterns that are processed manually in the run.
No preference – manual patterns are not resorted
First per material – manual patterns are at the start of each material
Last per material – manual patterns are at the end of each material
First in run – all manual patterns are at the start of the run
Last in run – all manual patterns are at the end of the run
