Saw parameter to set how parts are sorted on patterns
The optimisers usually generate patterns with recut parts sorted to the left (rear) of the strip.
This parameter reverses the layout so that recut parts are sorted to the right (front) of the strip.
For the Schelling saw (saw model number 51) recuts are sorted to the right by default: this parameter is disabled is saw model 51 is selected.
Check the box to set this parameter
- Recut
parts on the right (front) of strips
Notes
- This parameter only takes effect when optimising - to change an existing run change the parameter and optimise again
- Can also be set as a Material parameter at both board and material level.
- For the Schelling saw (saw model number 51) recuts are sorted to the right by default: this parameter is disabled is saw model 51 is selected.
