Recut waste at rear  

Saw parameter to control whether remaining recut waste is shown at the front or the rear of the recut block

The default is unchecked (recut waste at the front).

● Check the box to set this parameter

 - Recut waste at rear 

When this parameter is checked, the remaining recut waste is moved to the rear. This is required for some robot controlled saws. Examples are shown below.

Recut waste at the front

Recut waste at the rear

Notes

This parameter does not apply when:

- recut blocks are processed by combiTec method

- waste is split in the recut block

- editing the pattern