Box to set the part position for tongue and groove optimisations
Sets how parts are positioned in tongue and groove boards
The following values should be used: -
0 or blank = part has no tongue or groove edge, positioned in the middle of the board
1 = part has tongue edge, positioned at the tongue (front/bottom) edge
2 = part has groove edge, positioned at the groove (rear/top) edge
3 = part has tongue and groove edges, positioned in board the same width as the part
Notes
- This box is in the ‘Part’ section of the information boxes
- These part positions are only obeyed when optimising with the ‘Tongue and groove’ optimising parameter is set
