Use internal MPR label positions for patterns

 

System parameter to specify where label position is generated from for MPR nested patterns

 

If this parameter is checked and a part MPR contains a <196 macro then the label position will be imported and used as the position of the label on the nested pattern MPR files generated on transfer to machining.

 

tickbox9.gif Check to take the label position from the part MPR macro

 

Note

- The previous method to specify a label position can still be used instead, which is with a line in the comment section in the following format:

PLABEL,<xpos>,<ypos>

- If 'Use internal MPR label positions for patterns' parameter is not set then labels on MPR patterns will continue to use the component macro (e.g. number*.mpr[x] files). If the parameter is set, then the <196 label macro will be used for each part on a pattern.

 - Offcut labels will still use the component macro.