Cutting height - Minimum

 

Saw parameter to set the cutting height

 

 

For this parameter enter the minimum cutting height (book height) in millimetres or inches (depending on your measurement mode setting). You can use the minimum value to force cutting to a fixed minimum number of boards, for example, for always cutting 5 high with 15mm (3/4in) chipboard enter 75mm (3-3/4in) as the minimum value

 

If you set the minimum cutting height to a value which allows more than 1 board high this setting overrides the setting for over production in the part list. You can avoid excessive over production with this setting by also allowing a reasonable level of under production.

 

Note - setting a minimum cutting height of more than 1 board can lead to poor use of material.

 

A value of 0 is taken as a minimum book height of 1 board.

 

Notes

 

- Can also be set as a Material parameter at both board and material level.

 

 

See also