Problem with settings - path conflict

 

This occurs for 'Transfer to saw' if there is a problem with the settings for various paths in System parameters

 

For some transfer modes there are restrictions on how some of the paths are set because of the different ways in which the transfer modes work. This message occurs in the following situations.

 

If the 'Path for Online label PC' and the 'Path for saw data' are the same and the 'Transfer mode' is NOT set as '2' (Online label PC) or '6' (CADmatic 3).

 

If the 'Path for Online label PC' is the same as 'Path for Data' for any transfer mode.

 

If the 'Path for Saw data' is the same as the 'Path for data' for Transfer modes 3, 4 and 5.

 

Check the system parameter settings.

 

 

33044