May occur when editing nested patterns
When editing parts in a nested pattern the part can be positioned anywhere on the board, however, whilst the part position looks Ok in the editor it may not be correct when the board is machined. For example:-
- part border may go over the edge of the board
- part border may go over the edge of another part border
- part border may be too close to another part border
Some of these problems can be caused by the safety border area which is not shown in the editor
An error is shown for each part that is not in a correct position
Part position not correct Border 3 Part F-UNIT-END-LEFT
The 'Border 3' value indicates this is third item added to the pattern.
The Part value is the name of the part.
There may be multiple occurrences of the same part on a pattern but the border value is unique.
During editing the current border value is shown to the left of the nested pattern drawing next to the function heading.
The pattern can be edited by pressing the edit button. This closes the dialog and the first invalid border is automatically selected. If the Continue button is pressed the changes are be saved and the pattern can be corrected later.
33120 |