May occur when optimising with Nesting optimisers
The 'Minimum part separation' set in the Nesting template (Machining library - Drawing properties) does not match the separation in use for optimisation
The two values are listed. These two values must usually match.
The 'Minimum part separation' for Nesting optimising is set in the Nesting parameters or it may in some cases be overridden by a value in the material parameters.
Check the data
- It is sometimes useful to allow optimising where the Nesting template value for 'minimum part separation' is different to the value specified in the nesting parameters, for example to allow some parts to be closer together. In this case the warning can be ignored.
|
33140 |