Unable to optimise - min pre-cut dimension is too large

 

May occur with Nesting optimising

 

If the nesting parameter 'Board pre-cut' is set. This error occurs if the program cannot produce a set of patterns that fit into the divided boards.

 

The minimum dimension parameter must be less than half the original board width (Board width pre-cut) or board length (Board length pre-cut) otherwise the original board cannot be divided into two boards which both obey the minimum value.

 

Board pre-cut = Board width

Minimum width = 1000mm

Original board width = 1220mm

Minimum width board 1 = 1000mm

Maximum width board 2 = 220mm

 

In this case when dividing the original board one width is always less than 1000mm so no solution can be found.

 

Check the parameter settings.

 

 

33218