Unable to optimise - max pre-cut dimension is too small

 

May occur with Nesting optimising

 

If the nesting parameter 'Board pre-cut' is set. This error occurs if the program cannot produce a set of patterns that fit into the divided boards.

 

The maximum dimension parameter must be greater than half the original board width (Board width pre-cut) or board length (Board length pre-cut) otherwise the original board cannot be divided into two boards which both obey the maximum value. e.g.

 

Board pre-cut = Board width

Maximum width = 500mm

Original board width = 1220mm

Maximum width board 1 = 500mm

Maximum width board 2 = 720mm

 

In this case when dividing the original board one width is always more than 500mm so no solution can be found.

 

Check the parameter settings.

 

 

33219