Too many blocks for crosscut trim override

May occur with pattern amendment

This is one of several checks on edited patterns on exit from pattern amendment. It refers to the Optimising parameters for 'Trims'.

Where Optimising parameters 'Override rip and crosscut trims' are set these may not be obeyed by manual changes. If these settings cannot apply the fixed 'Minimum trims' are checked. In head cut patterns the fixed crosscut trims should always apply. If there is insufficient room to accommodate the fixed crosscut trim this error is displayed.

- Check the changed patterns and the parameter values.

- Select 'Continue' to exit the pattern (any changes are saved). Select 'Cancel' to make further changes.