Attention.gifToo many strips for rip trim override

 

May occur with pattern amendment

 

This is one of several checks on edited patterns on exit from pattern amendment. It refers to the Optimising parameters for 'Trims'.

 

Error_override_trims.png

 

Where Optimising parameters 'Override rip and crosscut trims' are set these may not be obeyed by manual changes. If these settings cannot apply the fixed 'Minimum trims' are checked. If the manual changes also do not obey the fixed trim limits this error is reported for the rip cut trims.

 

- Check the changed patterns and the parameter values.

 

- Select 'Continue' to exit the pattern (any changes are saved). Select 'Cancel' to make further changes.

 

33273