Attention.gif Separate runs for offcut patterns - conflict with offcut pattern position in run

 

May occur with transfer to saw. The error indicates the run and pattern number.

 

- The Saw transfer parameter: 'Separate runs for offcut patterns' is selected but offcut patterns are not sorted to the start or end of the run.

 

Runs must have offcut patterns at the start or end of the run. This may be achieved by setting the Optimising parameter 'Offcut patterns - position in run'.

 

Alternatively, patterns may be re-sequenced in Review runs to move offcut patterns to the start or end of the run (Pattern sequence).

 

33305