Attention.gif Template master part too small - check template blade thickness and trims

 

May occur when optimising parts which are based on a template

 

Where parts in a part list are based on a template (Pattern library) the template is not large enough to fit in the parts.

 

This is often caused by a mismatch between the trims and saw blade thickness settings in the template compared to the settings in the optimising parameter file used for the optimisation.

 

It may also be that the cutting list sizes have been edited manually after the cutting list was created using the master template or Cutting list rules may have been applied which alter the cut sizes.

 

The optimisation can finish but there may be patterns that cannot be cut or do not fit into a board correctly.

 

- Check the template and optimising parameter settings

- Check the cutting list sizes

 

 

33318