Saw model does not support waste parts

 

May occur with optimising

 

The following options require the optimisation to insert waste parts: -

 

i) combiTec recut processing

ii) Tongue and groove

If optimisations are configured for either of the above options the saw model must support waste parts. If waste parts are not supported this error is displayed and the optimisation cannot continue.

 

The following saw models support waste parts: -

 

21 Single saw Homag/Holzma CADmatic 1/2/3/4/5 / Giben - Optilink / Selco - CRLINK

22 Angular Homag/Holzma CADmatic 1/2/3/4/5

23 Three-saw Homag/Holzma CADmatic 1/2/3/4/5

24 Angular Homag/Holzma CADmatic 1/2/3/4/5 (with offset head saw)

25 Angular Homag/Holzma CADmatic 1/2/3/4/5 (with turntable at rip saw)

26 HOMAG flexTec CADmatic 5

41 Sliding table saws

51 Single Schelling

62 SCM Seziona

81 Single saw – CPOUT compatible

91 Homag/Weeke cutting centre

 

Check the saw model in use.

 

See also

 

33502