May occur on Saw / Group transfer or with Online Label PC
There is a problem with the link to the saw or other machines. The saw number and saw name are typically shown at the end of the message. The saw 'number' is the item number in the Saw transfer parameter list
Feeback from Saw - May also get communications problems when using the Feedback options with Run or Shift analyses and with the Module and Direct link modes of transfer to the saw.
These are typically problems with the link itself and not caused by data transfer or the saw transfer parameter set up. Check the physical link and that the communications programs (where required) are running. If the link has been working Ok then it may be temporary 'noise' problem so re-try the operation
35004 |