May occur if attempting to optimise a part list or review a run where there is no data
The optimiser (or nesting optimiser) could not find any data. There are several possible causes which are typically due to edit errors in the board list or part list.
- Part list or board list is empty
- Every item in the part list or board list has the quantity required set to zero
- If reviewing or printing run data perhaps the run did not optimise correctly and there are no valid results
- All parts may be set as 'Plus parts' (e.g. +PRT/101); 'Plus parts' cannot be optimised on their own
The message indicates which run number is involved. If optimising or reviewing a batch of runs there may be more than one run causing the problem.
- Check the part list and board list and re-try
35018 |