Action not successful - problem with open parts

 

May occur when optimising with a restriction on the number of open parts in patterns

 

Restrictions are set by the Optimising parameters: Max open parts and Max different boards

 

If, for example, the Optimising parameter: Max Open parts is set to a low value, e.g. 2 and neither of the available board sizes can fulfil all the cutting requirements then the limit on open parts may restrict the use of the boards so that a solution cannot be found.

 

The following part list and board list, with Max open parts set to 2 and Board limit field set as zero for each board size, illustrates this problem.

 

Optimising parameter: Max open parts = 2

 

Cutting list

Item         Size       Quantity

Part 1     650 x 350      250

Part 2    1100 x 650      200

Part 3     940 x 460      150

Part 4     870 x 725      300

 

Board list

Item         Size       Quantity   Limit

Board 1   2440 x 1220      40       0

Board 2   3050 X 1200     180       0

 

Only two part sizes can be allocated to each board size and both board sizes have to be used so the low Max open parts restriction can cause a problem.

 

No results (patterns) are produced if this error occurs

 

Check the parameter settings and board quantities.

 

Often a small increase in Max open parts avoids this problem or change the 'Limits' field settings for the boards to allow the optimisers to exceed the stock quantity.

 

Note - it is not always easy to reproduce this error as it depends on exactly how the optimisers attempt to deal with the Max open parts setting for each part list.

 

 

35035