Occurs whenever a file is missing or settings are pointing to a wrong location for the file
For example, if selecting a file on the 'File tree' and that file is no longer available. The message gives the full file name of the item not found. This may occur in a multi- user setup because the file has been recently deleted by another user or another instance of the program - and the screen or list is not up to date. In these cases if you exit from the program and re-load the list or tree the data is updated.
The problem may also occur if the network or drive may is not available or if you have recently changed the system parameter settings for paths.
At the Board library it may indicate that a selected picture or material parameter file is not available.
Saw simulator
- May occur during optimisation. The program cannot find the saw simulator control file e.g. HolzmaSimulator.ctl. This provides the link to the saw simulator program. It is part of the set up of the Saw simulator program.
Part list import
- Where the part description contains a path to a DXF file it may be that the DXF file cannot be found - check the path exists and the format for specifying the path is correct.
Import / Adjust stock from file
- If a user defined template is used for importing board data from an external file this error may occur if the template file (board import parameters) is not found or one of the settings is not correct. Check the system parameters and board import parameters.
Form/Label printing - stand alone
- If the TLF filename specified does not exist or the data file is not found then this error message will be added to the file formout.err
36008 |