Item not found - code

 

The item listed in the error message was not found

 

There are several causes of this message.

 

- Job costing report: if any of the fittings or operations on the report are no longer in the Part library. The report is not produced because the cost of one or more of the operations or fittings is no longer available. Check the part library data

 

- Optimising: if using the 'Quick edging' method in a part list with an Edging library and the codes are not in the Edging library and the codes are not in the edging library. Check the part list data. Note that the 'Quick edging' method can also be used without the edging library or edging module.

 

36013