Item not found - material

 

Occurs when optimising a part list, or product requirements and a material entered in the part list is not found in the board library

 

The message also shows the material code and line that is causing the problem

 

This is often caused by mistyping a material code

 

Check the part list data including any information boxes using material such as the information boxes for Front and Back laminates

 

It also sometimes indicates that a material has been deleted from the board library.

 

Can also occur for a part in the Part library where a drawing is also linked to the part and a section of the drawing contains a fill based on a material code. This either means the material code specifying the fill is not correct or the material code has been deleted or changed in the Board library since the drawing was created

 

 

36022