Attention.gif Data not correct - conflict with group

 

May occur on Saw / Group transfer

 

There are several causes of this error:-

 

- The column 'Warning' in the Saw transfer parameter list has been set for the Group and differently for one or more items in the group. The re-transfer warning method must be set the same for the whole group

 

- Where the saw transfer parameter: Separate runs for offcut patterns is set this error is reported if any of the transfer modes in the group do not obey this parameter.

 

- The transfer path for the group members is set to the same as the path for the group.

 

- Inconsistency between export image settings for group members which generate Pattern Exchange Format.

 

- Check the Saw transfer parameters

 

In all cases, the saw name of the group member with the error / inconsistency is shown at the end of the error message

 

Extra information may be given to indicate a setting which conflicts with other group members. For example, group members which require the PTX file format must have the same export image settings. Here the extra information might be:

 

   Setting: Pattern image format

 

37094