Occurs when optimising a part list or product requirements and the limits on some boards are set for ratios (1-3) and the optimising parameter 'open parts' is also set
Board ratios cannot be used with the parameter 'open parts' as these are often conflicting requirements.
Check the board list and the optimising parameter settings.
Note - if the optimising parameter for the number of open parts is set but is less than the number of part types (sizes) in the part list the open parts parameter does not apply.
The following board list and part list with open parts set to '3' illustrates this problem.
Part Material Size Qty
A CP1 500 x 450 20
B CP1 1200 x 345 20
C CP1 600 x 400 10
D CP1 925 x 450 39
E CP1 450 x 345 20
Board CP1 Size Limit
B1 2440 x 1220 1
B2 3050 x 1220 3
Optimising parameter
Max open parts, max different boards 3
|
38011 |