Data not correct - part too small

 

Occurs when optimising a part list or product requirements list and one or more parts is too small

 

Check data and parameter settings and re-try

 

The following saw parameters control the minimum size of part that can be optimised.

 

Min length of part in a strip

Width of strips – Min

The Clamp settings

 

This error is also reported if any part dimension is less than 5mm (or 0.25” in inches mode)

 

This error can also occur when saw optimising using the "Tongue and groove" optimising parameter and the "Tongue and groove - information box" setting of 3 for parts with both a tongue and a groove as these parts should be an exact fit on the width of a board.

 

 

38021