Data not correct - parts do not fit template

 

Occurs for: Create cutting list when templates are in use for grain matching for some of the parts and the parts allocated to a template do not fit the template

 

This is usually caused by not fully allocating parts to a template - the template calculations for the other parts in the template are then wrong.

 

Check the allocation of parts to the template and the template design in the part library.

 

The following template and part list illustrate this problem.

 

Part         Size      Qty

A       1200  x  500   1 - allocated to position 1

B       1200  x  500   1 - allocated to position 2

C        590  x  500   1 - not allocated

 

Because C is not allocated and B is the same length as A the template containing A and B is not correct.

 

 

38024