Occurs for Review or Recalculate runs where one or more of the patterns does not obey the setting for the Optimising parameter: Max unique parts per pattern, head cuts per rotated ptn
That is, some patterns have more part types per pattern than is allowed
The message also indicates the pattern(s) causing the problem
Check the parameter settings and part list data.
This usually indicates that the patterns have changed (pattern amendment) since the run was optimised. It may also occur when importing patterns if the import data is not correct.
Pattern amendment or pattern library - The error may also occur when editing a pattern in pattern amendment or in the pattern library. The maximum number of parts on a pattern is limited to approximately 2000 (depending on the number of parts in a strip). In this case you cannot make any more changes to the pattern.
38027 |