Part belongs to incomplete template

 

Occurs when attempting to create a cutting list

 

Some of the parts are not allocated to all the positions in a template.

 

Each template in use should have parts allocated to every template position in order to define the size of the template.

 

However, it is possible to have templates with some positions unallocated to parts.

 

For 2 dimensional templates each strip can have 1 unallocated position and if strips only contain single parts one strip can have an unallocated position. Waste parts

with the same size as the original template definition are added for the unallocated positions.

 

For 1 dimensional templates (i.e. 1xN or Nx1) it is possible to produce templates with more than 1 unallocated position when the "Allow incomplete 1D templates" parameter is set.  With this configuration, waste parts are not inserted and the template size is adjusted to the number of parts in the template.

 

Can also occur for Product requirements and/or Quotes / orders when attempting to estimate or create a cutting list.

 

38056