Data not correct - too many overs

 

Occurs for Review, Print and Recalculate runs where the number of parts produced for one or more part sizes exceeds the allowed over production (set in the Part list)

 

Check the part list data and re-try.

 

This problem often indicates that the patterns have changed after the run was optimised.

 

Nesting - The total quantity of parts produced in a nesting run is checked against the minimum (quantity required - unders) and maximum (quantity required + overs) quantity allowed - the quantity is not correct.

 

Note - can also occur for 'Import patterns'.

 

 

38067