Data not correct - too many unders

 

May occur for Review runs or Recalculate

 

This typically happens when the run data (e.g. part list) have been edited. This can also occur for 'Import patterns'.

 

At Review runs the program prompts to re-optimise the data.'Some parts not produced - re-optimise list?'.

 

Nesting - The total quantity of parts produced in a nesting run is checked against the minimum (quantity required - unders) and maximum (quantity required + overs) quantity allowed - the quantity is not correct.

 

For the shaped nesting optimiser (only) it may also indicate that there were not enough boards to complete the part requirements

 

- Check the part list and board list

 

 

38071