Occurs for Optimising if recut parts cannot be clamped by the first clamp
The minimum part size that can be clamped by the first clamp is determined by calculating the midpoint of the first clamp finger – i.e. at least 50% of the finger needs to be holding the material.
For example:
First clamp position= 75mm
Overall clamp width = 65mm
Finger width = 15mm
Minimum sizes of recut part = 75 – (65/2) + (15/2) = 50mm
This sometimes indicates the run has been manually altered after optimisation.
Check Saw parameter settings for clamps.
38079 |