Saw parameter to set whether information on recuts is required
Check / uncheck the box to set this parameter
Include
division of recuts
For example, sometimes recuts are taken on a separate saw so the times for these cuts do not need to be included on the run for the primary saw.
Notes
- Recut times are only relevant where the Optimising parameter: Recuts is set to allow recuts in patterns.
- Recuts can be taken on many types of single and angular saw but some angular saw model types do not allow taking of recuts (e.g. Compumatic) and in these cases the recut times are NOT included regardless of this parameter setting.
|