MPR(X) Header instructions 

 

Set header options in MPR(X) files

 

Enter each instruction in the format defined by the MPR(X) manual and separate each instruction with the semi-colon character.

 

HP="1";IN=0;GX=0;

 

The entry is not checked by the software and is transferred as entered to the MPR(X) file - make sure to check the entry carefully before transfer.

 

Make sure Machining centre parameter: TRANSFER MODE is set to a value of 8 for Homag WoodWop V4.0+.

 

These settings apply to the complete MPR(X) file.

 

Note - Use Drawing properties in the Machining library to set header instructions for each drawing.

 

 

See also