Optimise method for drilling

 

Parameter to set how drilling movements are calculated

 

 

Homag only

 

- Enter a number for the optimising method for drilling (range 0-999)

 

Refer to WoodWop for the list of numbers available and optimise methods.

 

The optimise method can also be set via the 'Machining library drawing properties' at each drawing.

 

 

Notes

 

- WoodWop 4.0 onwards and 2.5 - The Optimise method in the machining centre parameters sets the OP= function. The HS= function is not used and is dealt with by the parameter for Horizontal Drill movement mode.

 

- WoodWop 4.0 onwards (only when set in the Machining Centre Transfer Parameters)- The Optimise method in the Machining Centre Transfer Parameters sets the OP= function. The HS= function is not used and is dealt with by the parameter for Horizontal Drill movement mode.

 

- If the optimise method is set to either 1 or 2 and the drawing contains a pause instruction or instructions on the back the optimise method used is 0.

 
 

See also