Offset - X value 

 

Machining centre parameter to set workpiece information 

 

 

Homag only

 

The Offset - X value offset (with the Y value) gives the distances between the board and the zero point of the machine, that is, the right-angle step.

 

These values are also used when a part is too small to be clamped; the part is put inside a frame to hold it and the offset generated by the frame is added to the part instructions.

 

This is the FNX value in the '<100' section of the MPR(X) file.

 

The Workpiece information can also be set for each part at the machining library drawing.

 

See also