Saw parameter to set limits on packing strips
Use this to specify the minimum length for packing strips (waste strips). This prevents the packing strips being to short to use.
A value of 0.0 means 'do not cut packing strips at this saw'
Also set the saw parameter for: Width of packing strips.
Where the dimension of the waste in the direction of the cutting line is greater than or equal to this value the waste is divided into packing strips. If the waste is not large enough to be divided for packing strips the program follows the setting of the saw parameter for the size of the waste flap. If this is set the waste is divided into small strips that can fall into the waste trap.
This value can also be set as a material parameter.
|