Override cross cut trim

 

Optimising parameter to allow the crosscut trim to vary

 

 

The amount of trim can vary between the usual value (set by the Optimising parameter: Minimum crosscut trim (inc. saw blade thickness)) and a lower minimum value set by this parameter.

 

 Check the box to set this parameter

 

Override crosscut trim

 

 Enter a minimum value in the box alongside (Minimum crosscut trim (inc. saw blade thickness))

 

For example, if the usual trim is 20mm allowing this override and setting a new minimum value of 5mm allows the trims to vary between 20mm and 5mm. The new minimum value can be set to zero if necessary.

 

 Enter a value for the maximum number of parts per strip (Max parts per strip)

 

This determines when this parameter applies. If the number of parts in a strip is more than the maximum then variable trims do not apply and the standard trims are used instead.

 

 

Notes

 

- Can also be set as a Material parameter at both board and material level.

 

- 'Parts per strips' is the number of physical parts not the number of part types

 

See also