Transfer to saw - file names

 

Information about saw transfer and longer file names

 

Take care when transferring to saw controllers which do not support longer names. For example, the CADmatic 4 as a newer controller was designed for longer names but some older controllers may not have been.

 

When a run with a long run name is transferred to a saw which does not support them, the name is substituted with a short numeric run name, allocated from the System parameter: Run - last, use part list. The substituted name is displayed against the original on the saw transfer dialog.

 

Note  - where a run is divided because the run exceeds saw limits, the divided lists are always assigned a short, numeric run name.

 

Transfer modes and limits.

Mode

Rules applied

2  Online PC (transfer mode 2).

Numeric runs only, max 8 digits

3,4,5 CADmatic 1/2

Numeric runs only, max 8 digits

6 CADmatic 3

Alphanumeric runs allowed (no spaces), max 8 characters

6 CADmatic 4 (recursive)

Accepts long filenames (set via saw transfer parameters)

7 Homag

 Numeric runs only, max 8 digits.

8 Giben

 

Alphanumeric runs allowed (no spaces max 8 characters

Giben export to .AC files (mode 8) has a special rule to ensure that saw transfer is consistent with export of part lists (.AD files)

9 Schelling commander 4

Alphanumeric runs allowed (no spaces) max 8 characters.

10 SCM

Numeric runs only, max 8 digits

11 ASCII/Unicode PTX

Accepts long filenames

12 MDB PTX

Accepts long filenames

13 Schelling commander

Numeric runs only, max 8 digits.

14 CPOUT - cpout naming mode

(CPOUT.nnn)

Set via saw transfer parameters. The 3 digit extension number (.nnn)  is assigned from system parameter: Last saw group number

 

See also