Max distance from edge / centre

 

Saw parameter to limit the area for tension trims on a board

 

saw_param_tension_centre.png

The area allowed for tension trims is defined from the edges of the board or from the centre of the board. In either case use this parameter to the set the maximum distance from the edge or centre allowed for tension trims.

 

- Enter a measurement (e.g. 400)

or

- Enter a value as a percentage of the board dimension (e.g. 25)

 

The placement from the edge is set by the saw parameter: Placement from edge or centre of board

 

 

Notes

 

- Can also be set as a material parameter at both board and material level

 

- CADmatic 3 / 4 only

 

- If both values are set the greater of the two values (as a measurement) is used

 

 

    See also