Nested Patterns - set up

 

Preparing the system for Nested patterns

 

There are two summaries for Nested patterns:-

 

Nested Preview

Nested Patterns

 

These reports can be made available as follows:-

 

At any Review runs screen:-

 

 Select: View - Modify report bar

 Select Machining tab

 

Make sure the boxes are checked for these reports

 

Also check the settings for Printed reports, at any Review runs screen:-

 

 Select: File - Parameters - [ Printed ] button

 

Check the relevant boxes to include these reports.

 

Machine before edging

 

When generating nested patterns the machine before edging setting must be ON. To do this, at the main screen:-

 

 Select: Parameters - Machining centre parameters - Generation

 

Check the box: Machine before edging

 

Alternatively use the Information box parameter: Machine before edging

 

This can be set up via the Information box parameters. The box value must be set for each part in the part list(s) used for Nesting optimising.

 

An error is reported if Machine before edging is not set and the EL (edging) or BI modules are in use.

 

Board library limits

 

The Shaped nesting optimiser allows users to set a 'limit' value of '9' for certain boards - this allows the quantity of these boards used by the Shaped nesting optimiser to exceed the quantity in the board list. When the quantity used exceeds the board list quantity a warning is displayed:

 

For Shaped nesting optimisations the following board limit values can be used:-

 

Board limit 0 - do not exceed quantity in stock

Board limit 8 - unlimited stock

Board limit 9 - unlimited stock, a warning is displayed when the quantity used exceeds the quantity in the board list

 

 

 

See Also