Transfer to saw - retransfer

 

Machine Interface options when sending runs to a saw

 

Transferred runs are shown on the batch screen with a tick.

 

Saw_transfer_retransfer.png

 

Sometimes it is useful to re-send a run or to send the run to another saw. The program can be set (Saw transfer parameters) to give various levels of warning where a re-transfer is attempted.

 

- No warning on re-transfer

- Warning if run has already been transferred to the same saw number

- Warning if run has already been transferred to any saw.

 

If a warning level is set a warning dialog is shown on a re-transfer.

 

Saw_transfer_warning.png

 

The last five transfers (for a run) are shown.

 

Yes - confirm re-transfer

No - do not transfer this run (the program prompts for each run in the batch)

Cancel - abandon transfer

Help - information about this dialog

 

 

Notes

 

- The printed version of the screen uses an asterisk * to show transfer status

- Re-optimising and recalculating a run do not affect the transfer record

- Avoid rearranging the list of saws in the saw transfer parameters since this may cause confusion during saw transfer

 

 

See also