Saw parameter to set the maximum width of strips for the device
- Enter a value for the maximum width of the set of strips that can be taken by the device.
e.g. 900mm (36.000in)
This is typically the distance from the angle fence to the near edge of the first Non-retractable clamp.
Clamp positions - if the device is fitted then the clamp position parameters refer to the clamps on the main program fence. Enter the clamp positions in the usual way. Typically the first clamp is offset further than a saw without the device to allow room for the device itself.
Any clamps that are located within the distance set by this parameter are taken as retractable clamps.
|