Routing / Nesting system parameter to set directory for MPR(X) files
For example:-
C:\VER\MPR
These are the MPR(X) files referenced by the Part list / Cutting list when the Part list parameter: Drawing source is set to MPR()X files.
If the path does not exist the program prompts to create the directory.
If the parameter is left blank the MPR(X) files are located in the folder set by the System parameter: Path for Library data
Notes
- MPR(X) files for runs (generated on transfer to a machining centre) use the paths specified in the Machining centre parameters (Path, Path for back instructions, Path for horizontal instructions)
- Backup only includes MPR(X) files in the folder set by the System parameter: Path for library data
- If the path contains names of two or more directories that do not exist the program does not create the directories
|