Safe transfer

 

Saw transfer parameter to set whether safe transfer applies

 

The parameter is shown on the right hand pane at the saw transfer parameter screen and is only required for some saw modes. Select the correct saw transfer mode(s) before attempting to set this parameter.

 

CADmatic 3 / 4 / 5 / woodStore only

 

It is recommended that this setting is used if using a woodStore system.

 

If safe transfer is enabled the program checks that run data is successfully sent to the machine and an error is reported if it is not and the transfer is abandoned.

 

Check / uncheck the box to set the parameter

 

tickbox9.gif Safe transfer required

 

 

Timeout values

 

If safe transfer is in use the Timeout values must also be set. These determine how long the program waits before checking the transfer. The formula used is:-

 

Wait = First timeout value + (n x Second timeout value)

 

n is the number of runs transferred

 

Enter the two Timeout values in seconds.

 

 

See also