Saw parameter to set the number of boards for faster operation with small books
- Enter the number of sheets as a whole number, for example: 2
This sets the limit for using the faster operations. Any book equal to or less than this number of sheets is a 'small book' and uses the faster times if these are set.
Notes
- The program compares the two saw parameters:-
Max book for faster operation - Measurement
Max book for faster operation - Number of sheets
The number of books set by each parameter is determined and the smallest number is used for the program value. For example:-
Material thickness = 4mm
(1) Max book for faster operation - Measurement = 18mm
(2) Max book for faster operation - Number of sheets = 2
Number of sheets from (1) = 18/4 = 4
Number of sheet from (2) = 2
Value for the program: 2
Notes
- Can also be set as a Material parameter at both board and material level.
![]() |