Board margins

 

Nesting parameter to set the size of the margins on each edge of the board

 

mct1973-01.gif

 

These parameters set the margin allowed on each edge of the board.

 

- Enter a value for each edge

 

Parts are not placed outside these margins.

 

 

Notes

 

- Can also be set as a material parameter at both board and material level

 

- In some cases the margins are not set all the same, for example, where an edge is damaged the margin on that edge may be larger than the others. The program automatically keeps track of the margins so that if a board is used in a rotated pattern the correct margin is applied to the correct physical edge (as specified in the non rotated board).

 

 

   See also