Min. area for nesting on the edge

 

Nesting parameter to set a minimum value for the area of a part

 

mct1975-01.gif

 

Set a minimum area for a part that is large enough to be placed at the edge of a board (or at margin if board margins are set).  A part with an area smaller than this is classed as a 'small part'.     

 

- Enter a value in area measurement

 

For example, square metres or square feet.

 

Allow 3 decimal places e.g. 0.012

 

 

Notes

 

- Can also be set as a Material parameter at material level.

 

- It is also possible to set up the Information box: Do not place part on edge. This can then be set manually for each part at the cutting list. Only for Shaped Nesting and Shaped Nesting II

 

 

   See also