Nesting parameter to set path for the board template
This is an MPR(X) file that is used to process the board margins.
Specific MPR(X) variables are set in this file.
A board template is required if optimising with Shaped Nesting and one of the board margins is not set to zero.
● Enter a path for the template (if used)
Click
on the 'List' button to browse directories
Click on the 'Folder' button to 'run' the template
Typically this runs the editor (such as WoodWop) for that template so the template can be viewed and/or changed.
Example
[H
VERSION="4.0 Alpha"
OP="1"
WRK2="0"
O2="0"
O4="0"
O3="0"
O5="0"
FM="1"
ML="2000"
DN="STANDARD"
GP="0"
GY="0"
GXY="0"
NP="1"
NE="0"
NA="0"
BFS="0"
US="0"
CB="0"
UP="0"
DW="0"
MAT="HOMAG"
INCH="0"
VIEW="NOMIRROR"
ANZ="1"
BES="0"
ENT="0"
_BSX=2000.000000
_BSY=1500.000000
_BSZ=19.000000
_FNX=0.000000
_FNY=0.000000
_RNX=0.000000
_RNY=0.000000
_RNZ=0.000000
_RX=2000.000000
_RY=1500.000000
[001
_RPL="2000"
KM="Length in X"
_RPB="1500"
KM="Width in Y"
_RPD="19"
KM="Thickness in Z"
_RP1="10"
KM="Trim Left"
_RP2="10"
KM="Trim Right"
_RP3="10"
KM="Trim Bottom"
_RP4="10"
KM="Trim Top"
.....
Notes
- Can also be set as a Material parameter at material level.
- Shaped nesting only
![]() |