Nesting parameter to set the minimum size in length and width for an offcut
Set this value to reflect the size of material that is the smallest useful piece (offcut). A piece of waste is defined as an offcut by the following rules.
Longest side exceeds minimum length
Shortest side exceeds minimum width
Area exceeds minimum area
- Enter values for the Minimum length and width
- Enter the area in square unit of measure.
For metric use square metres, for Imperial (Feet and inches) square feet.
Notes
- Can also be set as a material parameter at both board and material level
- The 'length' is the value in the part list column labelled 'Length'
- The 'width' is the value in the part list column labelled 'Width'
![]() |